VGA compatible controller: ATI Technologies Inc Rage 128 Pro Ultra TF

[Mathieu Malaterre <mmalater at nycap dot rr dot com>]

Just a double check, did anybody manage to get (any version of) fglrx to 
run on a :

VGA compatible controller: ATI Technologies Inc Rage 128 Pro Ultra TF(*)

I have already done the very same steps on a ATI 9800 and everything 
works fine (well except SMP flags), but when I try the very same steps I 
get:

FATAL: Error inserting fglrx (/lib/modules/2.6.8-2-386/misc/fglrx.ko): 
No such device

So so far I am using the 'ati' driver that comes by default with debian 
testing.


Thanks
Mathieu

(*)
0000:01:00.0 VGA compatible controller: ATI Technologies Inc Rage 128 
Pro Ultra TF (prog-if 00 [VGA])
	Subsystem: ATI Technologies Inc: Unknown device 0409
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- 
Stepping+ SERR- FastB2B-
	Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
	Latency: 64 (2000ns min), Cache Line Size: 0x08 (32 bytes)
	Interrupt: pin A routed to IRQ 193
	Region 0: Memory at f4000000 (32-bit, prefetchable) [size=64M]
	Region 1: I/O ports at ec00 [size=256]
	Region 2: Memory at fcffc000 (32-bit, non-prefetchable) [size=16K]
	Expansion ROM at 80000000 [disabled] [size=128K]
	Capabilities: [50] AGP version 2.0
		Status: RQ=32 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64- HTrans- 64bit- 
FW- AGP3- Rate=x1,x2,x4
		Command: RQ=32 ArqSz=0 Cal=0 SBA+ AGP+ GART64- 64bit- FW- Rate=x1
	Capabilities: [5c] Power Management version 2
		Flags: PMEClk- DSI- D1+ D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
		Status: D0 PME-Enable- DSel=0 DScale=0 PME-
00: 02 10 46 54 87 00 b0 02 00 00 00 03 08 40 00 00
10: 08 00 00 f4 01 ec 00 00 00 c0 ff fc 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 02 10 09 04
30: 00 00 00 80 50 00 00 00 00 00 00 00 0b 01 08 00